ASTM F436 Hardened Steel Washers Price - Din6914 Heavy Hex Structural Bolts – Dingshen Metalworks

Ariens S 16 HP with a powerful Kohler cast iron 16hp gas engine. Hydrostatic drive, no gears to shift, it has a mid, front and rear pto with a class zero 3 point hitch. The rear PTO is shaft, gear driven. It weighs about 900 pounds. It comes with wheel weights, turf tires on front and rear, a 48 inch shaft drive mower deck, 3 foot 3 point hitch rototiller, snow/dirt blade and chains. The snow blade and chains were never used. I have the original packing slip and shipping sticker. This machine is a rare find. It was stored in a barn for over 15 years. Other then old gas in the tank, it started right -up. There is zero no smoke, I think the engine has under 500 hrs on it. This machine is no Lowes special, just the rototiller alone would cost over $2,000 from JD, and Ariens was the in leader in rototiller technology. This tractor will out live you. I re-painted the rototller, but the rest of the tractor just has some minor surface rust. I replaced the battery and ALL the belts, new hydro filter and oil. I repacked all the grease for the gear boxes on shaft drives for the rototiller and mower deck. Lights are also new, back light are original. This nice part about the tractor is it was never worked on, all the wires and nuts and bolts are original. The hydraulic control lever has Lift, Down, Hold and Float! Not even my new JD has that!!!!! I have ALL the manuals including the repair and parts list.
I started it when it was 20 degrees, turned over like a dream, first try. cold start

The Tiger Axle-Shaft Puller isn’t just another way to strike the axle-shaft, it’s a true axle-shaft puller. Any mechanic will tell you that the removal of drive-axles is usually difficult, time consuming, and often dangerous.

• Works on all medium to heavy-duty Eaton and Rockwell drive axles
• The Base bolts onto two studs while straddling an additional two for solid positive locating
• Has a spring-loaded 4140 heat-treated drive-pin case hardened and designed to maintain direct contact with the center of the axle flange
• Has fully adjustable pulling arms and stud adapters that are quick and easy to install
• Has a large drive-pin head extending well beyond the wheel providing, an easy target
• Eliminates damage to axle studs

Included Adapters:
11035 – 5/8″ x 18 (most common)

Optional Adapters:
11010 – 1/2″ x 20
11015 – 9/16″ x 18
11020 – 3/4″ x 16
11025 – 1/2″ x 13
11030 – 5/8″ x 11

https://www.tigertool.com/index.cfm?method=products.productDrilldown&productid=01b5055b-ab0f-c145-39d2-9b8d87af2a31&sortBy=DisplayOrder&searchText=11001&